Search results

Results 1 to 6 of 6
  1. J

    3-Point Hitch  Telescoping lift arms for G3038

    I just purchased a G3038 gear transmission tractor to use on our produce farm alongside an older NH TC45DA tractor that we have. I am already tearing my hair out because the G3038 does not have telescoping lift arms. I have gotten used to telescoping lift arms on our NH. We hitch and unhitch...
  2. J

    Hose connected to coolant drain plug on engine block TC45DA?

    I have looked at several older posts about the slow coolant leak from the drain plug fitting on the right side of engine block. The older posts describe this drain fitting as leading to a hose which then runs to the radiator. There is no such hose on my tractor (year 2006 - picture attached)...
  3. J

    PTO shaft spins slowly when PTO disengaged

    I have a TC45DA, 1400 hours. I have recently noticed that often when I first start the tractor the PTO shaft spins slowly when the engine is at low RPMS and no implement is attached. If I raise the throttle and increase RPMS, the spinning stops, or if I attach an implement to the PTO the...
  4. J

    E type locking ring

    I need to replace a part of the parking brake on my NH TC45DA. As part of this I need to remove and reinstall an E Type locking ring (described in the NH parts catalog as Locking Ring #62 .480" Dia., E-Type, #2 in the attached parts diagram). I cannot actually see this ring until I partially...
  5. J

    Tuff-bilt tractor

    Does anyone know anything about these tractors? Tuff-bilt Tractor System - Affordable and Innovative. They are a bit like an Allis Chalmers G with a hydro transmission. They seem like they would be a good cultivating tractor on our vegetable farm. I have read that a company named Cummins...
  6. J

    TC45DA lifting with pallet fork on FEL

    Just for reference, the other day I lifted pallets of soil mix off from a tractor trailer with a pallet fork on TC45DA front end loader. Pallets weighed 1600 lbs each. I have no wheel weights. My tires are filled with air. For rear ballast I used a 3-pt bale fork with a wooden bin on top of...
Top