Search results

Just had a FEL arm cylinder seal blow this last weekend and while taking it apart discovered a lot of old orange paint chips were the most likely cause. I put seal kits in all 3 cylinders on the FEL and found old paint chips between the wiper and the pressure seal for the chrome rod on all of...

Was just using my FEL when the up down lever jammed the bucket roll function (L,R on the stick) works fine but the lever will not move forward/back. The lock lever is in the unlocked position. Anybody have any ideas before I tear into it?

1. Pop plastic floor mat buttons to loosten rubber mat and remove the battery cover then clean (hose down) seat pan area under mat as well as other dirty parts. 2. Unhook battery - terminal ( safety to prevent possible short or any chance of motor turning over when working on propeler shaft)...

I amm tearing into mine to replace the propeller shaft boots. Got the seat, HST pedal, and mat off. How do I remove the cutting height control dial and the 3pt hitch lowering speed knob preferably with the shaft still attached so I can get the floor pan up?

Know this subject has been addressed again and again but I still haven't been able to get my head wrapped around it yet! I tore the propeller shaft boot on the engine end. I got the new $2.00 boot. Can I unbolt the 3 bolts in the front of the propeller shaft, drop it down slide the flange off...