Search results

Morning I do my own maintenance & tractor manual says it痴 time to check the valve clearance. Thinking of having a local mechanic do it. Questions - directions on-line somewhere or do I need to get sheet from dealer? Hard/time involved? Thanks

Bottom seal on garage doors tend to stack/freeze to concrete over the winter, despite my best intentions on keeping the garage dry. I致e used silicon spray with some success over the years, but was wondering if members have any recommendations? Garage is insulated (don稚 normally heat) with...

In November I was going to bush hog the back 40 with my Houzz but the coupler wouldn't move (some wet areas back there so easier to cut when it is either very dry or ground is frozen). Was fairly cold (-10C) so took it off but couldn't get it to loosen up after a few hours indoors. Sprayed...

Hi Anyone have any experience with value leader implements. I'm looking at their 5" PTO chipper as a possible purchase. Thanks

Was chipping some alders the other day & got a jam. Was a bit surprised as the alders were green so normally go through it like butter. Anyhow, after I cleared the jam, which didn't seem too bad as the piece I was chipping wasn't stuck, the flywheel on the Briggs & Stratton engine wasn't...

Stumbled across TractorByNet when researching tractors & some other projects. Own a JD 2520 with FEL & 5', 3pt hitch finish mower. Will be purchasing a snow blower sometime before the snow flies this winter. Live in New Brunswick, Canada. Brought up on a farm (on PEI) & currently live on 80+...