Reverse gear slow

[Gr2000guy]

Gr2000 real slow in reverse gear.
Any ideas?

 

[WinterDeere]

Gr2000 real slow in reverse gear.
Any ideas?

I know nothing about the particulars of a GR2000, but in nearly every other case with every hydrostatic tractor, loss or reduction of momentum in one direction with no apparent effect on the other direction is due to control linkage.

Look for wear, slop, or a pin that's fallen out. With tractor turned off, have someone move the controls while you watch the actual lever on the transmission itself, to verify complete range of movement.

 

[Wagtail]

TractorData.com Kubota GR2000 tractor transmission information

www.tractordata.com

G'day Mate and welcome to TBN from Downunder. Enjoy the site.

 

[SPYDERLK]

I know nothing about the particulars of a GR2000, but in nearly every other case with every hydrostatic tractor, loss or reduction of momentum in one direction with no apparent effect on the other direction is due to control linkage.

Look for wear, slop, or a pin that's fallen out. With tractor turned off, have someone move the controls while you watch the actual lever on the transmission itself, to verify complete range of movement.

Or debris captured at a limit point.

 

[Suburban Plowboy]

My L3710 tractor would barely move in reverse. I thought it was a stupid millennial mommy-culture safety feature. Turned out a bolt had fallen out of the pedal apparatus.

 

[lmichael]

I had similar with my G2160. Now it gets right up and moves along in reverse. Though my linkage still has a lot of slop and stickiness. Just not sure how much further I want to take it.

 

[WinterDeere]

I had similar with my G2160. Now it gets right up and moves along in reverse. Though my linkage still has a lot of slop and stickiness. Just not sure how much further I want to take it.

I had a 1963 Cub Cadet 123 who's hydrostatic control linkage was so sloppy by the early 2010's, that it was getting hard to control the speed at all. I ended up replacing all of the linkage but one piece I couldn't find. I think I sprayed some weld onto that piece and ground it back down to original profile, to repair the wear.

Point is, you can always make it new again, if desired. It's just not always worth the time and cost, unless it's getting very bad.

 

[lmichael]

Yeah, it's a little sloppy and sticky but not horrible. I've seen worse and it is fully controllable.