For you DIY folks, I found a set of 1/2" Ag couplers on Amazon for ~$16. Find an NPT reducer bushing, drill/ tap the inside diameter to the desired screw thread (1/4-20 sounds about right) and add a bolt, T-bolt, whatever your preference for a lower cost version.
DIY hydraulic pressure relief couplers
- Thread starter OldTrix
- Start date
- Views: 686
Harry in Ky
Veteran Member
And all this does what?
jigs_n_fixtures
Veteran Member
I think that it lets you bleed of pressure so you can connect fittings.
RadarTech
Elite Member
Yea it is pricey… but I bet if you counted your time, and labor to make one it would be about the same…
Many times I’ve bought tools after considering the cost it would take for me to figure it out and make it…
Case in point the clamps I use in the hydro fittings.. I forget the name..
it cost me $85.. the clamp itself is $45.. milling or cutting the new jaws would cost more than the $40 to make them myself…..
Many times I’ve bought tools after considering the cost it would take for me to figure it out and make it…
Case in point the clamps I use in the hydro fittings.. I forget the name..
it cost me $85.. the clamp itself is $45.. milling or cutting the new jaws would cost more than the $40 to make them myself…..
