zzvyb6's latest activity

Ensure that the wire is being pulled from the correct spool direction.

I have a set which lets you flip it from expand to contract by moving the hinge pin. Weak link for me has always been the tips bending...

Well, new ones don't arrive dull. It's not done for the dirt, but for roots, weeds, grass, etc.

Sharpen the blades ! Grass isn't being cut, just pulled out by the roots. Also try backing into the furrow instead of going forward...

Be careful moving that load. That much mix + water + sand + gravel (or just the pre-mixed recipe + water), is VERY heavy. Have a lot...

I have a JD 1435 diesel, 72" front mower, 60" broom for snow removal, and I also can run a 540 rpm Winpower pto generator on it with a...

My local hydraulic shop is a lot cheaper than my dealerships. Remove it and have them duplicate it.

I don't think so. I recommend a 3 series with a loader. Even a previous generation 390. Power and weight gets you thru all the tasks...

Here's another example of an incorrect installation on a Kuhn combo tedder / rake. The photo shows the driveshaft's C.V. joint now at...

The drawbar length sets the position of the hitch pin relative to the tractor's pto shaft's u-joint coupling on a driven shaft. This...

Incorrect. It requires equal co-linear AND co-planar alignment of the input and output shafts, with the center of the intermediate...

I'll agree with the other suggesting a new shaft for the front one. Also your drawbar is set to short, your drawbar hitch pin should be...

Although I disapprove of my doggos being anywhere near my machinery, here is the rest of the pack:

I just bought a 55" collapsed length 540 tractor end 21 spline baler end, CV jointed + slip clutch for $600 from this place. It weighs...

On the long shaft setup you should get a CV joint at the tractor end because angle differences will excite some serious vibration and...