Zork's latest activity
-
Zork reacted to WinterDeere's post in the thread Have I been using my weed trimmer wrong? with
Good Post.
... and if you do, post a link to the new thread here, so we can follow across. -
Zork replied to the thread Have I been using my weed trimmer wrong?.You should start a new post thread; I have comments but do not want to contribute to hijacking his thread
-
Zork replied to the thread Have I been using my weed trimmer wrong?.I think the excessive throttle is for his neighbor Ken.
-
Zork reacted to Slowpoke Slim's post in the thread Have I been using my weed trimmer wrong? with Good Post.
Only time I run mine wide open is when I'm cutting down heavy or thick stuff that needs it. Rest of the time its half throttle at best...
-
Zork reacted to Rockbadchild's post in the thread Have I been using my weed trimmer wrong? with Good Post.
Not me, I let go at each end of the swing when its not cutting and full throttle in the between (if required), a 2 stroke engine like...
-
Zork replied to the thread BX24 blowing hydraulic filters.I’m sorry if this post is irrelevant. On my Branson tractor there is only two connections to change/remove the BH. In this BX24 video it...
-
Zork replied to the thread BX24 blowing hydraulic filters.Years ago, when I first got my tractor, I finally disconnected the BH to install the arms/3 point equipment. There are two hoses I...
-
When you disconnected the backhoe what did you do with the hydraulic hoses? Did you connect them together?
-
For the OP could you please enlighten me as to exactly what is going on with the filters. You start out saying they are blown and then...
-
What bothers me is everybody is saying filter is in hydraulic circuit which I interpret as high pressure side.... Confused as to whether...
-
Yes it was what?
-
Zork replied to the thread PTO Shaft to Gearbox Bolts Keep Breaking!.A few things I can think of. 1- Is it a shear bolts? Slip clutches do not require shear bolts in the shaft as the clutch does the...