Recent content by zenmek

I had oil in my bellhousing also, looked like engine oil, but turned out to be hydraulic fluid, when I split the tractor. Replaced the input shaft seal and all was happy. Don't have any pointers for the clutch adjustment unfortunately.

An FYI for ya..I successfully used kubota rings in my lk3054 with no problems at all, and they were a lot cheaper! Good luck

Sounds like cavitation.... check your suction screen. And piping to the pump

Can anybody tell me what size R4 industrial tires come on an LK3054 :confused: , looking to switch from R1 ag's to R4's and the ops manual doesn't say. Thanks Will

Being the newest owner of an older (93') LK3054 with a kL122 loader on it, I have not been able to find any manuals for the loader. Mr. DePratt helped with the tractor manual (thanks Jon ), but no luck with the loader. Any one out there able to supply some info on this loader? Biggest question...

Actually the "powertrain" side of anybodys 2002 LK 3054. I know it's a pretty strange question , but i'm being told my recently purchased Lk 3054 is a 2002. Considering the overall shape.. I'm having trouble believing this! Any how the engine, tranny, 3 point,etc. is painted a metallic blue...

Does anybody know how to decode the serial # on a LK3054 so I can know the model year? Any help would be greatly appreciated. On another note.. I guess I'll have to add another toy errr tool to my sig pic Thanks for the help Will

I am currently thinking of switching colors and I have one little question on the B7800. Does the hydrostat have some type of "cruise control" as the B2710/2910 have? If so how well does it work? Thanks to all for any help

Does anybody know where the hydraulic filter for this tractor ( '78' MF 230) is?? Is it a spin on cartridge, or just a screen, or perhaps a hidden filter element. Any help would be great!!

I have a Buddy with a 78 MF 230, He went to use his bushog the other day and the 3ph wouldn't lift it, no noise and no loading of the engine. He said he could help the 3ph lift it, but it would drift back down. He has used the same bushog for many years, so it's not a weight issue. One thing...

I'm considering putting in a radiant heat floor system (concrete pad) in a future shop i'd like to build. I plan on insulating walls to R-19 and ceiling to a R-25~30 and use blue board under the pad. The heat will be supplied from a domestic hot water heater (electric). Does anybody have a...

I would like to tap into some of the infinite wisdom on this board (a little buttering up never hurts ). Any way should I be sharpening the tines on my tiller? I just can't decide if it is better to pulverize or slice. Any thoughts on this would be greatly appreciated!

I need a favor from the Kubota forum! I have a buddy looking to buy a L4310 or L4610 with a FEL and hydrostat transmission, are there any good/bad/otherwise comments that I can forward to him? I would greatly appreciate it!

Does anybody know if the dscv and related hoses etc. are a direct swap from a 755 to a 770? I know the FEL frame and hardware are the same. Any help, comments, warnings would be greatly appreciated. Thanks in advance