When I run my tractor for over 30 minutes or so, and run it fairly hard, the idle speed drops to where it shuts off. Also when it has been running for a while there's a slight squeal in a belt or pulley maybe? in the engine area. I just had it serviced in hope that they would fix the problem...
So it looks like I need to remove the floor panel on my GC2400 to access the wiring for the seat switch wiring that was damaged. I've never done this. Does anyone have any advice for me as I undertake this process? Is it really hard to do? Any advice would be greatly appreciated.
So my GC2400 would not start for a couple months. Turns out a critter or debris snapped the wires that connect the gear safety switch. I took off the switch, and it came out with about a foot of wires that were snapped off. I went under the tractor and can not find the other end. I looked for...
I have a MF GC2400 and it developed a leak of hydraulic fluid at the screw on filter. There's no fluid on the top or above the filter so I'm assuming the gasket has dry rotted and is leaking. Here's my dilemma. I went to the dealer and they sold me the filter ($30) and hydraulic oil (outrageous...
I have a Massey Ferguson gc2400 and I haven't been able to get it to start since Jan. The battery is fully charged, all fuses are good. If it sits for a while (a few hours), when I turn they key on, it takes about a minute before anything happens. Then the gas gauge will slowly start to register...
Greetings! I have a GC2400 and I went to start it and it only clicks. I hear the fuel pump going (ticking sound), all of the basics are in neutral PTO, Trans, etc. The battery is at full charge....it only has 139 hrs on it. It clicks like it's trying to engage the starter only after waiting 5...