xyz123's latest activity

Guys like Jeephead and you are bad influences on me. Now I am thinking about buying 3 more to donate to my favorite High School Tech Ed...

Dealer = Just pulled the walbro carb off the new g366 pro and it has the same markings indicating it is made also in the Thailand...

Was just showing someone my G111 200T clone. Over 5 years for my needs. But has took a back seat since 2511's came in to pic. Only for...

See that o-ring in there. Thats what I did to tighten fit on the V-modest one. It fits against the O of the intake base that seem shorter.

Did you get a oem air filter too? Going to need that also. Like said my oem one on oem saw fits looser then my farmertec one. Grease...

All freaking day too. Trying to stop buying them. I am wanting to set one back NIB to have or give as a gift sometime too. Only thing...

The alternative is to spend $540 on the 2511T like I did. I think for $100, it's worth the risk of performing some adjustments.

I run a good FD rated oils. My main go to is Vpracing with Efree 89. I got my Farmertec G2511 tuned in low 12's. Didnt check...

Here’s a post I did a while back with my original Zenoah RedMax from 2003. Back then Zenoah was owned by Komastu, the heavy equipment...

Walbro carbs on the Farmertec China clone saws I always figured they were made at the China walbro plant. Dealer contacted Walbro =...

Muffler testing wood picked out for oem and clone. Pipe, 2 cnc mufflers from different makers and the open clone. Going to use Oregon...

OEM way back. They also did it for husky. Couldnt give me one after running these clone 2511 now.

Yes that is it but green in color. 10" bar but almost 2 pounds heavier

You can use a heat gun to soften your PVC pipe and widen it a little, but then your other saws might fit a little looser.

A 70' oak blew down at my friends cabin. It was a good opportunity to get some hours on my Joncutter. My fiend was going to meet e out...