WranglerX's latest activity

Same here only I use a anti roll fixture that clamps on crossbar and goes to 3PH arm to keep it from rolling...

Using the rigid bars instead of chains is probably how deck got bent in first place.....

Would seem to me and my limited knowledge of hydraulic that looking at the whole system is sort of blinding the OP and others.... Sort...

Not sure what is heaviest, but most common easiest to fabricate with is concrete... It's about 150 lbs. per cubic foot... I made a 2x2x1...

Personally I don't think you can draw through tractor pump without tractor running , you are going to use log splitter pump I would try...

Got to love them Woodchucks..... Matched pair of Stihl MS250's with 16 inch bars.. Really old (1989-91) DURR 22 ton splitter ( bought...

These 2 never failed me lifting logs up to have off the ground when needed.

bet that was not the first word out of @dicktill mouth.

In theory if you do not do any blade operations that include that blown hose, it should not leak fluid as control valve theoretically...

If you are thinking of pumps.... https://www.surpluscenter.com/Hydraulics/Hydraulic-Pumps/2-Stage-Log-Splitter-Pumps/ Keep in mind you...

All I can say is OUCH.....

IF you tractor hydraulic pressure is only 1200 PSI and splitter cylinder id is 4 inches you are only getting about 7.5 ton ram...

No doubt the pressure is too low for the log splitter at 1200 psi, but increasing the pressure of the tractor will shorten the life of...

Works like a dream. Thank you all for helping me through this.

Complete new stinger, or just new liner?