WranglerX's latest activity

https://www.surpluscenter.com/Brands/AMA/Replacement-Tubing-Fittings-For-AMA-Top-Link-Cylinder-9-7682-T.axd

THink I would get a cable come along and put one end to tractor chassis at rear , and other end on FEL framework just above unseated pin...

Convert it to a PDF....

For your viewing pleasure..... And.....

For what it is worth most problem with QH is top hook does not meet the standard or top of implement does not meet standard.......

Chain link fence (or any "ground" fence) will eat trimmer line by the reel..... Wed burner may be answer....

Hit it with some mineral spirits, scrub it a bit and then flood with "Simple Green" scrub a bit with broom.... Hose off....

I responded....

Your $150 MIG machine aint going to cut it..... You are going to need a full 120/140 amp machine for that sort of project....

Think you are really going to be disappointed with the $150 machine.... The thing about welding is the machine is never big enough to do...

IF all the above items fail to show the trouble, you could pull drive motor assembly and test it with a 12V battery, most MIG welders...

Sounds like a parasitic load ... IF you disconnect a terminal on battery and put a voltmeter on disconnected terminal and battery post...

THE pressure on return line to filter and cooler has no relationship as to height/location as to outlet of control valve or height of...

Looks to me like a standard hydraulic system breather...

Why would it have a vent screen if it was not compatible....