WI_Hedgehog's latest activity
-
WI_Hedgehog reacted to MAX-24-Dean's post in the thread 4ft or 5ft Land Plane for Kubota BX with
Good Post.
It depends on how your driveway base holds up with freeze/thaw and rain and snow. I see you are in snow country, so I would recommend a... -
WI_Hedgehog reacted to BX23S-1's post in the thread 4ft or 5ft Land Plane for Kubota BX with Good Post.
I agree with dj1701 (post #7) I have a BX23s, go with the GS1548 You`ll want your rear tires loaded as well.
-
WI_Hedgehog reacted to dj1701's post in the thread 4ft or 5ft Land Plane for Kubota BX with Good Post.
I have a BX 2680 with a 48" land plane. My advice is getting the 48". When I start digging down deeper to get the potholes out, I can...
-
WI_Hedgehog reacted to oldnslo's post in the thread ? about Hydraulic Hose VS. Steel Pipe with Good Post.
Do you have the equipment to bend hydraulic tubing? If not again Parker Hannifan will have the tubing benders, clamps, etc. to make this...
-
WI_Hedgehog reacted to mjncad's post in the thread ? about Hydraulic Hose VS. Steel Pipe with Good Post.
SCH 40 pipe is the wrong stuff to use. It's not rated for that kind of pressure, nor is it manufactured to the same tolerances as steel...
-
WI_Hedgehog reacted to Egon's post in the thread Material for hydraulic hard lines, Copper-Nickel or only steel? with Good Post.
proper rated compression fittings. There are different types but you will not find them at the local hardware. A proper fittings shop...
-
WI_Hedgehog reacted to JFoy's post in the thread Anyone Running a Woods TSG50 Stump Grinder w/ a BX23s? with Good Post.
I have a Woodland Mills stump grinder on my BX25. It works fine but you do have to go slower as the tractor will bog down if you are...
-
WI_Hedgehog reacted to TresCrows's post in the thread What implements are Kubota BX specific??? with Good Post.
With the BX, as compared to the 2410, did you run out of power, or did you run out of traction? I ask because I have often wondered if...
-
WI_Hedgehog reacted to BMan2005's post in the thread Buying Advice Case IH or Kubota with Good Post.
Like Truby said the Workmaster & Case Farmall A series are twins with different paint. Not sure why the loaders they are fit with would...
-
WI_Hedgehog reacted to dbritt's post in the thread How about a grease cartridge thread? with Good Post.
The only info you need in selecting grease is the number of adjectives in the description. The more words like Ultra, Heavy Duty...
-
WI_Hedgehog reacted to manzer7's post in the thread How about a grease cartridge thread? with Good Post.
I sold some TRC greases and oil - (Very Long-Lasting product AND it's been around since 1922). I had to quit since farmers around here...
-
WI_Hedgehog reacted to NibbanaFarm's post in the thread How about a grease cartridge thread? with Good Post.
The Lucas heavy duty green is polyurea based. It's not compatible with lithium based grease. Don't mix them.
-
WI_Hedgehog reacted to TugHillDog's post in the thread How about a grease cartridge thread? with Good Post.
Red grease. Trouble is that where does it squish out to and is there a danger of blowing seals with too much grease? My wife has had...
-
WI_Hedgehog reacted to tjandrews's post in the thread How about a grease cartridge thread? with Good Post.
At 76, I sometimes think that I should have one of my doctors install a zerk on each knee. Then I could give them a couple of shots each...
-
WI_Hedgehog reacted to boatmoter's post in the thread How about a grease cartridge thread? with Good Post.
I use mobile one synthetic grease or sometimes marine grease, it stays on even if it goes underwater. I use a hand pump grease gun I...