Recent content by weeder

I have a real long hose on my grease gun

HA HA

No but I do have a nice hyd jack that will lift it pretty high and with at least 1 wheel off maybe I can get to it.

Thanks, I will try that when it cools down outside. My old body can't take the humidity and heat anymore like it used too even in the garage with a fan.

It might be easier for me to remove the rear wheels to give me room to get my arms back there to remove the PTO slip connector?

I greased it about 2 yrs ago when I had the deck out to weld some holes on it

Yes, I am, could a person take off the rear wheels and get to the serts that way? It is very hard for me to remove the deck and reinstall. I also don't have anybody close that could do it for me.

I need to grease the PTO driveshaft on my 54-inch mower deck. Is there an easier way to do that without having to remove the deck?

Ok thanks for the advice this tractor is always stored inside out of the weather especially in the cold never more than 40 degrees inside in the coldest months.

Well it is diesel tractor but the label said it is for diesel? I'm confused?

Well I have already bought some T5 10w30 is that ok?

Time to change the oil in the 1705 Massey, a friend said to use shell T5 10w30 is that a good oil??

Well I finally got it must of been in a bad bind but finally it went in to place. Thanks for helping me.

No this is the bracket that hooks to the mower deck and fastens to the frame of the front of the tractor that holds the front of the mower deck up

Oh yes it works I just had to open up the hole on the right side where the tapered shaft of the steering cyl goes thru that has the nut on it. Prob made in china is why it was a little bigger than the left side. But it works fine now.