Recent content by W5FL

It is Jordan tractors in Idaho. There are lots of posts with further information and phone numbers. Good Luck.

I can find a dealer that stocks a lot of parts for TYM. I bought all the filters for my 50 hr service and they shipped them to Texas. They are located in Oregon and if you search this board, you can find them. They probably can't get you warranty parts, but if you can get the parts you need...

Thanks everyone for the assistance. I now own a bucket full of hydraulic quick connect connectors and changed the ones on my grain drill. I learned not to remove the connector while the drill was raised. Got about 1 gallon or so of hydraulic fluid all over me from the change when I unscrewed...

This is a better photo. I believe it is a 1/2 inch ISO7241-1 Series A. Photo is on end of flail mower cable. These are the male connectors and the female quick locks are on the tractor. Click on photo to enlarge. Do these replacements simply screw on end of cable using teflon tape or locktite...

I have M6800 Kubota for over 20 years and it seems to use Ag Type connectors for all hydraulic fittings as do my Drill (planter), Post Driver, and hydraulic top link on Kubota M6800. I recently purchased new TYM T-1104 and all hydraulic fittings are similar but different and will not fit. Of...

All of mine kinda blew up at once. I had to take them off and measure them and write down the fittings. Many hydraulic shops and some auto supply shops can build you new cables. Don't skrimp on good cable material. Most shops will give estimates over the phone, but with all the loader...

Congrats on the new tractor. I suspect my neighbors could hear me moving hay into the barn at 1:00 in the morning, but the lights seemed like daylight. I think it makes a very nice farm tractor for me and I love the a/c. I have never seen any derating, minimum DEF use and sounds like regens...

I bought my TYM T-1104 in November 2022 for $64,700+$91.10 heavy equipment tax. 110 hp and came with everything,except implements.

I have recently purchased a new T1104 and it is a wonderful tractor so far. Lifts over 4000 pounds on the forks or bucket. Used it to stack 32 2000# 4x4x8ft rectangular bales under the barn overhang, that my 68hp Kubota could not do.

Sometimes I think my tractor has too many nannies, but it will not move with the parking brake on. My old M6800 would run until you could smell the brakes with the parking brake on. My TYM T1104 seems to have learned a lot from Kubota and will not go using the power shuttle until the power...

I have not pushed the fender buttons, but I would expect them to work just like the Bosch control and move the 3 point links to the correct position and stay there. I have not tried it yet. The main differences in the Kioti PX1153 and the TYM T1104 is the TYM uses newer electronics except for...

Hi again. How long have you had your machine and is it still in warranty? How did you find out what the code meant? If it really is a potentiometer they are not very friendly in a wet environment. I looked at the position device and it was a very long device, so it could be a potentiometer...

Thanks for the comment LouNY. I was actually looking for a Branson 80 hp, but they were never really available. The TYM is really a nice tractor. The hi/low is auto clutch and on the fly, so it is a really nice feature for me. When you need a 1/2 gear increase or decrease, just push the...

Hi M_Beaty. Glad to find someone else with the same tractor as I have a lot of questions. Have you found any good tym forums that cover the 100 hp tractors? I love TBN, but not many people have tym tractors. Have been waiting today for the freight guy to show up with my Titan 86 inch...

Yes, I am sure that is true since TYM, Kioti, Mahindra and others pioneered the SCR Catalyst system. Below 75 hp, none of then have DPF or use DEF. I considered a Deer and have an old one in my barn now, but the new six series Deer Utility tractors compare with the new TYM T-1104 6 Series TYM...