Recent content by versabob

of course you were right, mine has creep mode too, not inching, its been an interesting road, i know a lot more about telehandler now since trying to diagnose issue,there is no dealer near me for a 100 miles and that dealer has been shall we say,,,,non responsive.its frustrating because im...

thanks for your reply xfaxman, yes ive tried all three steering modes and no go in any of them, i have downloaded a service manual but thus far cant find much on the inching control, i may try to bleed the brake system(to address the 70-28 eror code) and make sure there isnt an air pocket in...

hi xfaxman, im getting the codes 50-15 and 70-28 on my v417, still have a no-go forward or reverse, ive changed out the magnet on the rear spoolvalve at bottom of cab,magnet had failed and valve would not activate,i also had not power at the valve so have put in a layout wire line,now have power...

Thankyou btw for your suggestions

Code is displayed 98-98, red light did not go out when in f or r when rpms increased, I will try and find a service manual online to download as a pdf, I have no idea where those wires would go to drive solenoids,unless you access from under the machine,,its freezing rain here and about 25degreesf

The only other thing I could figure was brake-related, ie brake malfunction so it wont activate machines driveability

Ok,,will do,, I've already tried starting in both f and r, yes my fnr light comes on and beeps,,machine will start fine in neutral, revs freely,, just no forward reverse

My local bobcat dealer could not find that code,but, he did not sell me the v417 either,,I love the machine,just put new HD cans tires on her

Code is 98o98, I've not been able to find that code anywhere, I'm going to test shift lever wiring harness, I've sprayed female plug with contact cleaner, my uneducated guess is that this problem is related to shift lever,

Hi xfaxman, I see you too have a v417 bobcat, I'm new to forum, I posted a request yesterday, my v417 stopped movement while pulling up a tree, all hydraulics work, boom just no forward reverse, I had just put machine into 2wheel steer from 4wheel, I've got a solid red warning on and I have the...

im new to this forum,hope someone out there can help i was skidding logs out with this v417 telehandler, went to switch it from 4wheel steer to 2 wheel and it just stopped, all hydraulics work, engine runs normally,got a red signal light on dash and a error code on code reader,contacted bobcat...