Our 9650 combine will not lock into 4 wheel drive. It makes a clunking noise and jerks the machine real hard while it tries to engage. I'm wondering if anyone else has had this problem or if anyone has suggestions on how to fix it. Thanks
Our tractor is leaking where the transmission meets the rear drive shaft. Any ideas how to tighten the bolts before we have the tractor pulled in half to replace a gasket?
Thanks
When we put the hydraulic remote in detent they don't release... We have the timer set for 3 seconds and have the dial in the arm rest set to 1. Any suggestions on how to get this working?
Hi, I was wondering if anyone has had any luck getting the pto shafts apart on a cih 600 blower. When we try pulling it apart, it bangs like something is stopping it
Our MX 285 keeps having these codes pop up and shots the tractor down to minimum throttle and you cant do anything with the tractor. Did some research and seems like either the solenoid or passive terminator is probably the problem. Anyone know how difficult it is to install the new updated...
Our MX 285 keeps having these codes pop up and shots the tractor down to minimum throttle and you cant do anything with the tractor. Did some research and seems like either the solenoid or passive terminator is probably the problem. Anyone know how difficult it is to install the new updated...
We have a John deere 6420 and the auto light, located near the PTO lights on the right of the cab, is always on. I cant find out what it means or why it came on. Our tractor still runs the same. Thanks for the help.
We have a John Deere 6420 and the auto light, located near the PTO lights on the right of the cab, is always on. I cant find out what it means or why it came on. Our tractor still runs the same. Thanks for the help.
We recently purchased a used MX 285 and every time we turn on the PTO, the PTO Fault warning comes on and there is no PTO speed reading. Any suggestions on how to fix it or where to locate the PTO speed sensor?