TractorTech's latest activity

Power out of pto switch to ecu. No power out of ecu.

Wondering why you would suspect new ecu to be bad if you have power out?

Found this on another forum: You can get the display to show you a trouble code. From the 2016+ X300-series tech manual: 1. Safely...

Welcome to TBN! Perhaps explain what you have done so far, but with that said, have you applied power directly to the clutch? Checked...

Yeah, I wasn't concerned as to the cylinders themselves, but looked at the loader valve as possibly not correct. However, your bucket...

Correct on the loader lift cylinders. It's a little frustrating as you rely on weight in the bucket to do any back scrapping but I have...

The current hoses look to be 3/8" and 1/2" would be my recommendation. I think the big problem, and you can't change this without making...

You can't remove the Priority pack as the sense line out the left side going to the remotes is what tells the pack to send oil to the...

Beautiful job on the restoration! I remember getting a MF? with the Standard diesel in our shop. It threw us for a bit because we were...

After 20 months, I have finally finished fixing and restoring Dad's 1960 MF35 Diesel. It was built in Coventry, England and shipped to...

AND the model number is??? SR

No , you’re relief valve setting will always be your high pressure limit. With the same gallons per minute flow the retract side of cyl...

Just keep in mind that you would be adding an engine, pump, tank, filter, and possibly valve, plus a bunch of hoses and fittings. So...

My knowledge is old and broad, not just Fords. I may not know the old JDs inside and out, but the hydraulic system in those are basic...

IF you tractor hydraulic pressure is only 1200 PSI and splitter cylinder id is 4 inches you are only getting about 7.5 ton ram...