TractorTech's latest activity

You need to look for a replacement and not leave it until you have problems as it will deteriorate and could cause problems with your...

With nothing attached, the 3pt should lift easily. Is this a new problem? Was the 3pt working before? Check or change your hydraulic filter

Can't tell exactly where the leak is on the unload valve, but disconnect the lines, unbolt valve and reseal with new orings if the leak...

The 8035.05 is basically the same block/head, but if it is a complete engine, you will have different output and different emissions...

So i actually had a digitally controlled fuel actuator (part # 7027792) instock and on my shelf, i installed with high hopes of...

It could be that you are cutting too fast or too much grass for the mower. If the clutch was slipping, it would not bog, but would slip...

I want to hear the outcome

Okay, I found on another forum, (VWVortex, go figure) a similar problem. I copied the solution to shorten the post, but added the link...

Work smarter, not harder!

It was rainy the other day so I was looking for a geezer putter project. I ended up making a suitcase weight rack. Just a simple little...

Welcome to TBN! Did you replace all of the springs in the shuttle spool assembly? I'm thinking you may have an old, weak spring on the...

Thanks for taking the time to give me some input.. This lift is actually oil cooled, not water cooled. And what is confusing me is that...

Welcome to TBN! The following models use the same pedal assembly: 1320, 1520, 1720, 1920, 2120, 3415, TC30, T1510, T1520, T1530 You...

Not sure on how easy or hard the fix would be, but it looks like a compression type or flair fitting on the line side. The fitting where...

Welcome to TBN! Water cooled I believe? Sounds like a temperature problem, so I would look at bypassing the temp sender or replacing it.