TMGT's latest activity

Exactly, I switch between forks and bucket regularly. Also comes in very handy when loading/ unloading the ssqa implements on and off...

Looking at the workshop manual page that was posted, I would start by checking the charge pressure for the HST, looks the relief for it...

The nylon liners are for aluminum, the only machine I know of off the top of my head that uses a metal liner for aluminum is Fronius...

To the OP, does the filter fail immediately or only after an operation, like driving or turning or using the PTO?

It is, the only cartridge filter is the hst filters, the only other hyd filter is the suction screen. I couldn't remember the exact...

I own a PAS266 and have used other Echo pas units, all tighten down on the tool and have no play. On mine, once tight,the pin could be...

I don't think you understand, you don't have to get out of the seat operate the QA, only to switch from QA to remotes which you have to...

Something is wrong if the clamp isn't tightening down on the tools shaft, if you weren't able to get it tight and the pin was the only...

Factory relief on the loader circuit is about 1750psi, empty loader lift is maybe a couple hundred psi. The filter on the BX is part of...

The 4043 is a preferred wire for most general welding on 4, 5 and 6000 series aluminum as long as it's not getting anodized or has a...

Not entirely true, while a metal liner may transfer some current to the wire, the contact tip can be the only transfer area. We run...

They will probably either not rent them in those states or require that they only be towed by one of their vehicles that is...

Like what? Haven't really used the Kombi setup.

You could get a link with a threaded stud and remove the existing ball, or use a through hole ball joint with bolt and nuts if you can't...

There are a couple that list ball size, but for the ones that don't just reach out to McMaster and see if they can get you that info...