Recent content by Tjaltz

I’m running the Bush Hog RTC50G tiller on a B3200. It requires 15 PTP hp, and my B3200 has 23. It’s gear drive, made in Alabama and has a Chinese gear box. I’ve used it for 4 seasons and have no complaints. You have to be realistic with what you can do when breaking up grass/clay. I started by...

I ended up piping the rear remotes in permanently, after the WR Long 3rd function and using the power beyond capabilities of the summit rear remote valve to have a dedicated power beyond circuit for the backhoe or anything else I need it for, while still having functioning rear remotes.

I have a B3200 with a power beyond port installed for a backhoe. I recently had a WR Long 3rd Function installed by my dealer. Now I’m adding (on my own) a two spool manual control valve for rear remotes. I have the piping laid out and just want to make sure there is no problem with my design...

The tractor’s rear PTO output spline (and connected PTO shaft to tiller) stop turning, and the tractor‘s forward motion stops. Rear PTO engagement is accomplished by depressing the clutch and moving a lever. Tiller PTO shaft turns easily when not connected. Tiller and PTO shaft are new, with no...

I have a well maintained B3200 with 300 hours on it. It has hydrostatic drive with three ranges. I recently added a 50 inch Bush Hog tiller that has a PTO shaft with a slip clutch. I made sure to slip the PTO shaft clutch by following the directions to loosen the bolts, turn it on and make sure...

I always blow out my radiator and condenser with a radiator genie after I mow or brush hog. If I’m out all day and it’s hot, I’ll blow them out on my break. When the condenser starts to clog, the cab warms up fast. The reflectix on the underside of the roof helps keep the recirculated air cool...

Thanks for the tip. When I took mine off I noticed they were not that tight, just snugged up.

Thank you. Pretty much what I’m doing.

My L6060 has an in-line valve on the heater hose that goes to the heater core in the roof. When I set the cool-heat blend knob to the coolest setting, a servo closes that valve and I don’t really feel any hot water running through the heater core hoses. If the insulation and tint don’t improve...

It puts out 60 degree air early in the day, but after 6 or 8 hours in the South Carolina sun, it can’t offset the heat coming through the cab glass and the air ducts in the plastic roof are heating the cool air output to the cab. It works great on hot overcast days. It’s all day in the sun where...

I have a 2019 L6060HSTC and on hot summer days my AC struggles to keep the cab cool. I regularly blow out and wash the radiator and condenser fins and make sure my cabin external air filter and internal air filters are clean. I plan on tinting my windows eventually, but right now I have the roof...

LD1: Thank you very much, that was helpful. I think I have a clear understanding of the lines now. I just have to identify the Tank Return line to tee in the tank return on the new valve. When I looked through the install manual for the Summit Hydraulics EVK2-3 valve it only shows 2 connections...

Thanks for the photo. I was thinking of doing something similar with the Summit Hydraulics electric valve kit. I’m thinking of installing their 3 spool valve, and using two of the spools for the rear remote top and tilt, and use the third spool for my 3rd function, by running a pair of hoses up...

Thank you. Your picture is helpful.

thank you.