Recent content by tinygiant

Did you ever finish this project? I'm looking to do the same on a 7060 and would like to see how it turned out for you, and what equipment you went with (the power unit). Thanks!

Thanks, will look.

Thanks, will look at that one also. Anyone have experience with the IronCraft Hydraulic Power Pack? 21gpm, fewer bells and whistles. How important is the cooling fan? The assumption is I'd be running skid streer implements such as brush cutters, trenchers and the like. Thanks, Ed

Thanks, will start looking ...

I own a Kubota 7060 that runs 11-12 gpm. I'd like to have the option to run some skid-steer attachments that require a flow closer to 22-25 gpm. Can anyone point me at a recommended product (like a PTO hydraulic pump, or even something that could be mounted permanently, if it exists) for this...

Hello again all... I have an old post driver that I rebuilt. It's one of those types that has a large I-beam that lifts up with hydraulics and drops by gravity assisted by springs. I've been using this successfully for several months; however last night while driving a 6" post for a fence...

Hello again all, I have a post driver that requires constant hydraulic pressure and the ability to quickly dump accumulated oil. I had this setup on my old Deere 3720 and it worked great. On my current M7060, all I have is an auto-cancelling rear remote and it doesn't let the oil flow fast...

Using numbers off the attached image. The feedback rod (28) has no noticeable bending or other issues. I adjusted the location of the feedback rod by adjusting the nuts (24 x2) across the range of about an inch. This had no noticeable affect on the frequency of pulse. All this adjusted...

Hello all, I've done some research on this, but haven't been able to find very many answers. I have an '07 Deere 3720 with a FEL and power beyond (for the backhoe, no other hydraulics beyond normal tractor stuff). The backhoe is detached, so the power beyond is return-looped. Today, when...