Recent content by theultimatetoolcat

Hoping I can get away with just tilting the housing a bit to gain access/see if I got it all, as opposed to unbolting levers, joysticks and wires. On an unrelated note, anyone know a good spray to get rid of a mouse piss smell?

Exactly what I was looking for, thanks! Hoping I can just tilt things to get a better look under to see if I got it all. I'll definitely have your post handy. Thanks again.

Tried to get what I could, still a little too narrow for my vac attachment. Was hoping this thing would be easier to pop on and off. 🙃

Anyone have a photo or can recommend the proper way to remove the center console on a 5600? Have what appears to be a mouse nest inside of it, and would prefer to clean it out. Can only do so much through the hole for the boot around the arm control. Seems to be a clip in the front, but I can't...

Stinger looks interesting. Didn't see anything from Homestead with dual grapples. But I might have missed it.

I'm not, I'm in Ohio. I've actually hard of ANBO, but I didn't realize they were willing to do custom units. Not that two separate grapples is anything crazy custom. Looked on their site and didn't see anything that featured two, but I might have to give them a call and see how doable is it.

Hey guys, Shopping around for a grapple rake, and I know what I want, but it is proving to be elusive to find. Looking for a grapple rake with the shorter bottom teeth, and not a root grapple. I'd like it to be between 48-66" inches wide, have two clamps on the top, and not weigh 1200 lbs...

This is super helpful. Almost went with a wider deck, but bobcat wanted $900 for the wheels up front. How does your unit perform at that RPM? Any issues?

I did notice that, but the standard also has a pretty noticeable jump on tip speed. Right now it's just chest high heavy grass. I plan on mowing it more frequently so it doesn't get as high as it is, but nothing beyond grass and the occasional small bush. Nothing close to that 3" diameter limit...

Solid advice. No oil cooler or external tank. Sadly, I don't think the RAMMY flail mower, or Kunz unit would be able to handle the amount of land I'm trying to maintain. But I'm willing to hear of other alternatives, or at least get to the bottom of my initial GPM question

Hey guys, Tried posting this in the toolcat forum, but didn't really get any bites. Hoping I'll get a bit more information posting here. I've got a Bobcat Toolcat 5600 with the high flow hydraulics. Standard is 18.9 GPM, and high flow is 27.9. I'm interested in getting a Bobcat Brushcat...

Bit of a silly question, but if I just got a high flow 5600 from 2020, and I wanted to snag a 72" brushcat. Should I go with the standard flow or high flow brushcat? TC has a 18.9/27.9 GPM flow. Standard brushcat 72 uses 15/26 GPM on min/max. I'm not going to damage to brushcat by attaching...