Menu
Forums
Today's Posts
New posts
Search
Members
Current visitors
New profile posts
Search profile posts
Top Posters of the Month
Classifieds
Auctions
Database
Quick Review
Quick Owner-Page
Register
Log in
Join
What's new
Search
Search
Search titles only
Today's Posts
New Posts
Search
Members
Current visitors
Top posters of the month
Menu
Log in
Join
Forums
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
thclimer's latest activity
thclimer
reacted to
civilian's post
in the thread
Another barn build
with
Good Post
.
I ran my gutters through a different pipe in the ground than my perimeter drain which was lower because of a partial inground basement...
Sep 3, 2025
thclimer
reacted to
hayden's post
in the thread
Another barn build
with
Good Post
.
I'll install a perimeter drain, just like you would do on a house. There is an easy run to daylight for the pipe. I'll also probably...
Sep 3, 2025
thclimer
reacted to
buckeyefarmer's post
in the thread
Good morning!!!!
with
Good Post
.
Took ranger down to creek. You can see the new guy wire on the pole and the inspector looking. I was able to get the ZT between it and...
Sep 3, 2025
thclimer
reacted to
LouNY's post
in the thread
Good morning!!!!
with
Good Post
.
One pod should be more then enough. These modern front loaders use so little water that I've found it requires at least one and I...
Sep 3, 2025
thclimer
reacted to
Eagle1's post
in the thread
BX2200 -- will almost start
with
Good Post
.
If the stop solenoid is removed and the starter spins over good, there is nothing electrical keeping it from running except the lift...
Sep 3, 2025
thclimer
reacted to
Eagle1's post
in the thread
BX2200 -- will almost start
with
Good Post
.
Just a thought did you change BOTH fuel filters? The one under the tractor near the lift pump is normally the one that fills up with gunk
Sep 3, 2025
thclimer
replied to the thread
BX2200 -- will almost start
.
I'm betting on fuel issue and as Eagle1 has noted I'd be looking at that fuel solenoid. Good luck.
Sep 3, 2025
thclimer
replied to the thread
Broke my B26TLB rear axle shaft
.
Wow, that's crazy! Did your dealer give you any idea on the repair timeframe?
Sep 3, 2025
thclimer
reacted to
civilian's post
in the thread
Broke my B26TLB rear axle shaft
with
Good Post
.
Sunday was not a good day for me. Was supposed to be an easy day, haul some dirt back to a clearing to level a spot for a deer blind...
Sep 3, 2025
thclimer
reacted to
Jhalupa's post
in the thread
2011 JLG Ariel lift with Duetz engine not starting when Hot
with
Good Post
.
my plan is to dig into the lift when i get some free time this afternoon. I will comment with what i figure out!
Sep 3, 2025
thclimer
reacted to
TractorTech's post
in the thread
2011 JLG Ariel lift with Duetz engine not starting when Hot
with
Good Post
.
Okay, I found on another forum, (VWVortex, go figure) a similar problem. I copied the solution to shorten the post, but added the link...
Sep 3, 2025
thclimer
reacted to
Eagle1's post
in the thread
BX2200 -- will almost start
with
Good Post
.
Only thing that comes to mind is the stop solenoid. I had one that would not retract all the way and did some weird stuff like that. Had...
Sep 3, 2025
thclimer
reacted to
hayden's post
in the thread
Another barn build
with
Good Post
.
Progress continues.... I finally finished getting all the rock out, and of course the last part was by far the hardest, quite...
Sep 3, 2025
thclimer
replied to the thread
Another barn build
.
What is your plan for drainage where your walls are near the hillside?
Sep 3, 2025
thclimer
reacted to
California's post
in the thread
Electricity Price Increases
with
Good Post
.
Maybe these guys? My favorite pruner. Joost Mfg Co of Berkeley. It was worth repairing when a bogus conduit handle someone had added...
Sep 3, 2025
Forums
Top