thclimer's latest activity

That squigly one is called a "Rue pin" or a "ring cotter pin" I bought some about a decade ago. They work really well if you can...

Walbro carbs on the Farmertec China clone saws I always figured they were made at the China walbro plant. Dealer contacted Walbro =...

I think someone has too much sentimental value tied up on that property. However, time will tell if the market thinks so. It will be...

The alternative is to spend $540 on the 2511T like I did. I think for $100, it's worth the risk of performing some adjustments.

KJ, I read every page and every detail and my 2860 with 150 hours on it behaves just like yours, exactly. It’s really frustrating and I...

That's good to hear, let us know what your dealer is able to find out.

That is exactly my issue that the 1740M is having, thanks for the link. JWR I got on the phone with AGCO and my dealer snapped into...

I run a good FD rated oils. My main go to is Vpracing with Efree 89. I got my Farmertec G2511 tuned in low 12's. Didnt check...

Pulled the oil pump, found the issue, it may be resolved. If not, cheap and easy fix. Will address tomorrow. She runs like a raped...

Here’s a post I did a while back with my original Zenoah RedMax from 2003. Back then Zenoah was owned by Komastu, the heavy equipment...

You can use a heat gun to soften your PVC pipe and widen it a little, but then your other saws might fit a little looser.

Here is the thread you were referring to: Massey Ferguson 1740M Hydro: LOSS OF POWER when hot!

Glad to see everyone enjoying their new saws! My echo 2511T is the saw that is always with me on the tractor. The Egan muffler was put...

On the Echo saw, and many others there are limiter caps on the high and low carburetor screw's. These caps only allow so much...

I saw where someone took a Dremel to the muffler cover to make it easier to install the chain. I plan to wait a bit to see if I learn...