Recent content by Tchamp

Do you like to barter?

I would get a [emoji637][emoji638] V lightbulb and put it across that circuit that has the power and while the unit is grounded out somewherein the circuit the lightbulb will stay lit. Go along the circuit disconnecting individual items on that circuit until the light goes out when the light...

I live inToccoa Ga and i have several pieces of pt acessories for my 2425 if you would like to drive down to ck it out. I am about 40 miles or so from you i think

Does it perform better than the old unit?

this is what I did to my stump grinder some old conveyer belt did the trick

I’m going to put a set of wheels on the front and the back of it that like casters that swivel I haven’t gotten them yet, but I just float it on the big brush and stuff right now. I’m going through the woods cut and I just let it float about 3 inches above the ground and let it cut

That pump that I have it turns the PTO at 400 RPMs, but the shaft is a one and a half to one so my blades are spinning at 600 RPMs it works better on it than it did on my yanmar tractor It cuts underbrush really well ,briars and thickets. You just raise it up over the top of them set the blade...

Another thing you can do is check tire pressures, make sure they’re not over inflated because if they are, it will give you a much different ride. I run 12-17 lbs on mine.

That is the same pump used on the Scag hstm I bought one of these use for parts for $350 and pull the pump off of it and send it to Terry and have them rebuild it for around $1000 and put on my 2425 last month so if you can get your hands on one of those With a bad motor or a bad deck or...

You could use the PTAs a counter balance on the digger as well win-win

It is the same pump but the scag turns opposite. Dont know if this will work or not. Has different plugs on both sides gonna have to do some research.

Scag pump installed

Older scag sthm tram pump will fit in older twenty four twenty five and the twenty four twenty two powertrac.Ask me how i know…

Yes

I dont know what is going on there??? That is weird.