tassmannn's latest activity

Have you tried turning the engine speed control dial up past 1/2?

Yeah, I did that in step 5. I have a buddy that works on these, and he told me he knew this machine and it sat a lot, and he has seen...

Blame OHSA and the entire nanny state of mind. They used to be easier and there were several designs that were more operator handy. They...

One would think 'they' could extend the length of that push button so those with a man-sized finger wouldn't have to push it through a...

So, I acquired a 33g high flow and just got a High Flow Brush Cutter. It works great, but I noticed that when I run it, it seems to make...

Seems to have hit a sore subject, and I thought I was the only one who had issues hooking up and unhooking up a bush hog :ROFLMAO::ROFLMAO:

Wow I never would have guessed this thread about hooking up a bush hog would grow to 10 or more pages !!!

I have a Kubota L4600 and a Land Pride 6' bushhog. It used to take me 10-20 minutes to put it on and at least 10 to get it off. This...

Sounds like you could use the PTO link;);)

I DESPISE hooking up my RCR1260 60” “bush hog”. Have Quik Hitch. My cutter has the telescoping drive shaft, and the push button on the...

Yeah, I have some stories too, but I also had a buddy that was stuck down in a well cavity that was sent to ICU, and now carries an EPI...

I see a lot of people writing about having to manually move the mower around to get the 3-point links onto the pins. But if your mower...

I have been using my Laneshark alot. Using it right now. Hours at a time. No issues. Who told you it would tax the hydraulics?

@walnutman The JD dealer who was selling it. He said I could run hedge trimmers off my third function, but not a land shark. What is the...

I usually have trouble lining up the lower link arms to get them attached. The rest is easy. I sometimes have to pull the mower to...