I now have new seals installed and the input shaft assembly back together. When I took the input shaft assembly and the pto bearing housing apart the two gaskets crumbled. I think they were original. These gaskets are paper thin and are almost translucent. I do not know what type of material...
I now have the clutch bolted to the flywheel. The 6 bolts are 5/16 grade 8 bolts. The service manual calls for those bolts to be torqued at 28-32 foot lbs. While torquing one bolt broke broke before I reached 25 foot lbs. I decided to replace all 6 bolts with new grade 8 bolts. Again while...
Again thanks. Your advice has been very appreciated. I will attempt to do this in the next few days. I may have more questions once I get in there. I will let you know how I make out.
Thanks for the reply. My transmission is a 6 speed non multipower. The manual only describes how to dismantle and rebuild the complete transmission. Do I need to remove the the pto bearing housing shaft inside the bell housing for the pto shaft to drop enough to remove the the input shaft. Once...
I am presently replacing the clutch on my MF 135 and noticed that the input seals are leaking. I have purchased new seals and would like to replace them while I have the tractor split. My service manual says that I have to also split the transmission from the differential in order for the pto...