SPYDERLK's latest activity

I bought my first backhoe attachment when I was in my 40's and it took less than 10 minutes to put it on and do the take off. When I was...

I would make it rather than pay that if I had a sample piece to go from. But Iv got all the stuff + experience on hand to do it. I doubt...

No, but what difference could that make in the case of a person paying, maybe $100, for a part he could make in a hour, only if he had...

Grinding : Lathe tools for groove and chamfer. Boring : Counterbore with chamfer. Charts : Research. Expensive: Overhead - How...

Lots of dimensions missing. Need skill in grinding tools. Boring. Knowledge of gland sizing and compression. IOW, experience.

Ya-ay! Even crazy prices are usually cheaper than making it yourself. Theres often a whole lotta overhead needed, + knowledge, skill...

Because Progress Integrated over Time = Zero. We are currently well into the downswing of the sine wave. But since Nimco is American...

Hi. The shaft that runs the fan on the old Ls is driven from a flex plate on the water pump pulley. The shaft extends forward about 8"...

Youre right. A roll pin is a really bad choice for a torque limiter for several reasons; > it is an open section with spring temper...

Does your tractor have wet or dry brakes? I am surprised at a recommendation of AW32 as that is a hydraulic only fluid, it is not a...

45-50-1 it’s not rocket science. I think people overthink this stuff. The new oil is miles better than the crap from back in the day...

Providing a container sufficient for someone to give you over 100 million 1$ bills is opportunistic indeed.

Greedy! ;)