Hey Guys,
I have a 425 4-wheel steer (low serial number) with a leaking front hydraulic steering cylinder.
The more I read, the more confused I'm getting regarding the proper replacement cylinder. (repair not feasible since the only hydraulic shop anywhere near me doesn't seem to be...
Have a BX with LA344S loader on the way (eventually) and will be making a half-a**ed bucket forks prior to its arrival. I need to know the measurement from the cutting edge of the bucket to the point where it makes its first upward bend.
Can't find that spec anywhere online.
Thanks in advance...
Have a BX with LA344S loader on the way (eventually) and will be making half-a**ed bucket forks prior to its arrival. I need to know the measurement from the cutting edge of the bucket to the point where it makes its first upward bend.
Can't find that spec anywhere online.
Thanks in advance for...
Does anyone know when the transition was made from the plastic cam gear that was on the earlier John Deere 345's? I'm thinking I read somewhere that it was actually sometime during the production run of the 345's, but I cannot find the model year that incorporated the change. Also, am I...
Folks,
I need suggestions regarding what USED mower/small tractor to be looking at. There are too many models and too little info on specs available for me to be able to research this thoroughly, so was hoping to pick the brains of the knowledgeable folks here on TBN.
I was thinking Kubota...
Folks,
I need suggestions regarding what USED mower/small tractor to be looking at. There are too many models and too little info on specs available for me to be able to research this thoroughly, so was hoping to pick the brains of the knowledgeable folks here on TBN.
I was thinking Kubota...
Hoping to get a little advice from the folks here on TBN.
I'm planning on building a double-sided privacy fence, 12' tall, to reduce the noise of a neighbor's barking dog. My plan is to isolate the outer wooden materials on both sides from the 4X4 posts using a layer of foam that is normally...