The 50 hour service calls for the hydraulic strainer to be cleaned. I've seen the Hamiltonville Farms video where Hank says he loses 3.5 to 4 gallons of fluid. I could have sworn Ive read that its upwards of close to all of it doing the cleaning. Anyone else have any comments on fluid loss...
Any current owners of a 3525 out there i could use some assistance. I need a picture or 2 of where the accelerator cable connects to the pedal to where it goes underneath the right side of the dash. I know it screws onto a bracket underneath on that right side dash but thats it. Mine got busted...
I got an 07 3525 that I need to replace the steering cylinder on. A Mahindra cylinder goes for $400 and up from what I致e found so far. Does anyone know of an aftermarket cylinder that I could use instead? Thanks.
I got a flat on my big rear tire on my 2007 3525 and didnt have the proper equipment to get it off this weekend. So i gotta go back this weekend and get it. My question is does anyone know what size socket to use to remove the lugs on the wheel. Thanks for any help that anyone can give.
Just like the title says. Ran fine on Monday night. Came out Tuesday morning and it will turn over but wont start. Went ahead and changed both fuel filters and bleed it but still nothing. Battery is fairly new so Im thinkin she has enough cranking power. Sounds strong when it turns over...
Got them all over my land. Want to get rid of them. Any suggestions as to what chemicals to use. Something that wont effect my horses. Thanks for the help.
My neighbor asked if I would come over and do some shredding on his property but I had no idea as to what to charge him. He has 20 acres with alot of trees and overgrown brush. It's not going to be a straight shot cut by any means. He basically just wants me to hit all of the open areas that...
What is the pressure you keep your well tank at? I have a 100psi tank but am not too sure what the pressure should be set at. Also what should be the gap in pressure from when the well pump turns on to when it turns off. Mine is at about 20 pounds difference. Say if the pressure is at 60psi...
I'm getting ready to plant some olive trees out on my land. The wildlife around there will eat them up if I don't put up a good fence. My main worry is keeping the deer out. Tractor Supply has some 6 foot high fence. Is this going to be high enough to keep the deer from hopping over and...
When you check the fluid level on a 3525 do you check it after the indicator has been screwed down all the way or just by sticking it in and pulling out? If you screw the it in it goes down about another 3/4 of an inch and it gives me a full reading. If I just stick it in I'm well below the...
I'm wanting to spread out some grass seed on certain areas of my land. I'm down here in Columbus Texas and was thinking of using bermuda. Any thoughts on other types would be apprieciated. thanks.
I posted this on the Mahindra section but figured I'd try it out here also. Sorry for the double post...
I've posted before that i have a hydro leak on my ML230 front loader on my 3525 where one of the lines goes into the pump. I haven't done anything about it but figure I would try to do it...
I've posted before that i have a hydro leak on my ML230 front loader on my 3525 where one of the lines goes into the pump. I haven't done anything about it but figure I would try to do it myself without having to haul it in 80 plus miles to get it fixed. It actually looks like it may be just a...
I got a !@# $%*% hydrulic fluid leak on my 3525. Looks like it's coming out on the right hand side on the tractor where a line screws in close to the engine block. Hoping that the nut is just loose. Didn't have much time to do a good inspection. I hope that it's something easy. I'd hate to...