scottu5's latest activity

My guess is shifter drums need to be shimmed tighter together &/or replace bushings(item 9). Check for excessive wear on latch(item 6)...

Sounds like you blew a seal in the cylinder. The bleed holes allow the pressure to not build up where it isn't supposed to be in the...

What do I think? I think you're way off base on all counts. Overloading the PTO (if you actually did that) would affect the life of the...

Thanks to all that answered. As it turns out it was the starter hot wire. Last thing I checked of course. Was initially convinced it...

You are missing #12, rubber bushing that goes over the cable end bracket

Finally got a chance to install @tedward4's kit on my 1620. Pretty easy install. Minor fabrication for the hose support bracket. Also...

Hello, Not certain of your equipment / setup, but I believe you are describing "remotes" (hydraulics for controlling attacments). If...

checked the delivery fittings, 2 were loose. retorqued, changed oil, mowed for over an hour. oil pressure now 40 at rated rpm, 20 at...

My ford 1620 had a leaking hydrostatic unit. Wanted to split it on the concrete floor in the garage area and to fit better, I took off...

Never open both valves on a charged system. OK, step one. all the gauge set ups I have used when checking your pressure the manifold...

High side seems abit high, maybe a touch to much freon. From some of my literature; "Before the vehicle is started, the...

It's real. A known problem with that series of TC engines. Lots has been written about it. It's a design feaure...er, problem or...

They sold tons of these TC series machines with the japanese engine. And I bet there are still tons running around every day. My machine...

Thank you!

Harry we all have to learn someway. And yes I suspected the expansion valve as well.