Recent content by roman

Kioti CK 4010

I will trade you my R fours that have Grip Studs.

Load light and carry LOW

can anyone tell me the size of the fuel and return line on ford 1720? thank you Roman

OK I feel special...The left downrigger cylinder has a leak on the hose connection. I tried to tighten it but the hose kinks up and it still weeps under pressure. What is the smart way to tighten the two nut hose connections to stop the leak and keep the hose straight? Thanks

I notice LS has roots in Hyundai and then bought by LG. Are they dependable and well built? Thanks, Roman

I replaced fuel filter and forgot to open fuel petcock. Ran system out of fuel and now I cant get it to bleed. I followed steps in manual but it wont pick up fuel...Now what?

I have been toying with replacing the plow with a 60" blower. Ford 1720 PTO HP claimed at 23.5 and it is a 12 speed shuttle shift. Will it have the nut to move our average 8 -12" storm? Thanks!

My tractor need a new clutch ,has a Sims cab and the shift lever pops out of second gear. Can someone tell me how many hours this repair should take? Thanks

We burn 4 cord and season it a full year plus.I use a 3pth carrier made of plate steel and the FEL to move the 4' longs (burn 16"). Either off my two acres or 1/2 mile away at a friends woodlot. He trades huge yellow birch, cherry and maple (largest so far 28") for tractor work. We stack the...

Ford 1720 (1998) with shuttle will pop out of 2nd when motoring, but not under load. Slight hand pressure on shifter keeps it there. What could the issue be and how to correct it? IF we continue to get the precipitation we have, and it turns cold...we'll be digging out for the entire winter...

I am considering moving my firewood with 28 hp tractor and slip-on bucket forks(haven't bought them yet). We stack wood on each side of the pallet with the middle open for drying. The pallets are actually three together so I dont need to make stacked wood ends. One pallet on the bottom-one on...

We live in an area with high peat levels in the soil. Our driveway consisted of dirt, a little gravel, large tree roots and a few large rocks (iceburgs). After a good rain the drive was like mashed potatoes and in spring, forget it. We stayed off it and used pallets to make a path to the house...

I need to replace some grease zerks on my rock shaft and the loader. Does anyone know the size? Are they threaded or push in type? Thanks!

I just made this ballast barrel, used stuff I had on hand. The only thing I bought was seven bags of quickcrete and 2" PVC. I also used a few hundred pounds of fieldstones. The barrel was shortened about 8" off the top. Made the initial cut with sawsall and trimmed it with a dremel tool. I...