Recent content by rockshaft

I don't know what these cost at the store, but this ebay deal seems good (I bought one) 14$ delivered Mr Funnel Fuel Filter Funnel Removes Water and Debris from All Fuels | eBay

'06 Titan CC SE BigTow Proline V-nose cargo trailer (was about 8k# in these photos) My 1026TLB fits inside In Montana In Yukon T or BC

I have an approx 27ft long tandem axle boat trailer and i'm thinking on some mods and would like opinions. 1) the drop leg jack is fairly close to the coupler. I was thinking of relocating it back a couple feet, inside the "A" part of the frame. 2) the spare/mount is on the outside of the...

I wish I could say the same about my otsix Titan, the dang storage locker seems like it attracts water, and I can't figure what is wrong with the seal or how I might fix it. I have my air spring fittings mounted inside, but otherwise I don't store stuff in there- just gets sopping wet. I have...

I've never used a pre-made mold, but I made a mold out of melamine for my countertop project.

I had a major gelling problem earlier this winter, even with triple treated PowerService (white bottle). I think I must have had a bad bottle of PS, because I switched to another brand and the problem is gone (after lots of frustration, change of filter, and ample use of hair-dryer). Now I'm...

The shed is a Shelter Logic garage-in-a-box, its the SUV model that has a tall door.

Yes, JD Yellow HD extension cord for FEL accessory control. The base of the actuator is on a bracket attached to the FEL multi-mount and plow base plate. Maybe this pic shows a little better. Its not pretty, as I can't paint all the bare metal parts until the summer when it warms enough.

We've had a warm up recently, it was in the upper 20's. Chains, and about 500-600lbs of ballast in back & about 150lbs in the front. Next project: affix my new JD bottle opener and cap collector to my ROPS!

8-10" of new snow. Tractor is working as a John Deere should!

I've never been all that impressed with various methods/products I've used to protect steel equipment. Would *love* to hear what has given good results for anyone else. Products I've used: Rustoleum Zinc Sel Rusty metal primer Clean metal primer Industrial Hammerite Seems like the best case...

I'm looking for the *inside width* of the 49" materials bucket for the 1-series (probably same for 2305) loader bucket. I'm trying to order a toothbar and I don't have the tractor to measure myself. I'm leaning toward the BXpanded Piranha version, but I'm considering others too...