Roadworthy's latest activity

I had a Mitsubishi D2510 four cylinder. Without glow plugs it was difficult to start on a hot day (over 100) and not wanting to go at...

Your success with either type auger will depend to a large extent to the ground in which you are digging. Either method will only go...

Are the glow plugs good? Do you have voltage to them? How did you "prime it up"? There's a specific sequence for bleeding the air out...

The curve in the video was interesting. Also, based on the additive package and what product it's used in, the shearing of the oil...

One must evaluate need before considering a generator at all. I've been in this house about twenty years. It's an all electric home...

I got a Pat's Quick Hitch for my tractor. You can buy it in Cat 1 or Cat 2. Mine is Cat 1. I appreciate it for its ability to take...

The shortened shaft should be fine. Just remember to cut the same amount from each half.

The shop should have resources to locate what will work. My Mitsubishi's Bendix went bad. My local shop found a new starter with...

Follow JWR's advice. 2013 was before Tier 4 requirements kicked in so you may be alright. Look the muffler over for sensors and wires...

You can try jacking up the loader then blocking or securing it in some manner in that position. It could weigh 600 pounds or more. You...

I would start by making sure the float is adjusted within limits and the needle valve is free to move, not sticking.

Does the starter really continue to run after the engine starts or does the Bendix fail to disengage? These are two separate issues...

I had a Mitsubishi tractor. The dipstick was on the right side of the engine near the back and low enough it could reach into the oil pan.

You're getting some good suggestions. You might also check the condition of the brushes. They could be worn out.

Seals generally have a number. It's the same from manufacturer to manufacturer. Kubota doesn't make seals. Try a seal catalog or even...