Recent content by rmg

'06 M9540 (900hrs) will not shift into 1,2,5,6 gears high or low ranges. Shuttle Shifter has also been hard to work. Took housing apart around gear shifter yesterday & found a nut was missing to a cable that is attached to the left of the gear shifter. Could this be the problem? Cable also...

why doesn't clutch work on my 1010? I worked on the road most of last year, so 1010 sat. Now when I try to put tsmn in gear while the clutch pedal is depressed, all I get is horrendous grinding. If I then kill the tractor and restart it in gear, it will move but will not stop when I depress...

Lowered pallet fork on top of one of our portable tubular stock panels yesterday. Mashed top rail down about a foot and a half. Of course all the other rails in that panel bent with it. How can I straighten this panel out without making it worse? I don't think my normal cro-magnon method of...

Just bought a slightly used Danuser PHD with hoses. Everything was laying on ground. Do I need to drain and flush the hydraulic hoses? If yes, how would I go about doing that?

Where do I grease the joints of the control lever linkage to my LA1353 FEL? Is the owners manual talking about the four ball type contacts under the boot at the bottom of the control stick shift? Or are there some other joints elsewhere?

On M9540, at 50 hour service interval, refilled transmission using 63.4 qts per owners manual. Well apparently that was too much. Can't even tell where level is on dipstick, it is so high. Can see some of the fluid down in the fill hole. Have learned from this site that some fluid stays...