RjCorazza's latest activity

I don't feel so bad now... I dropped my forks WAY into a pile of cut trees and brush. Ended up getting a chain on it and dragging it...

Every winter in Buffalo borders on disaster from my mid Atlantic point of view. My preparedness mostly surrounds fuel and equipment. I...

We switched one hvac zone from all electric heat pump to electric with natural gas "emergency" heat that kicks on at 40 degrees f. We...

My LuckNow blower also has very close OEM tolerances around a 4 blade fan, and a large slowly curved 12" diameter chute.

The bolt patterns between my Land Pride rear blade and HLA front blade are exactly the same (both 7' edges). Perhaps your bucket edge...

I believe the OP is referring to a failed registration attempt on another tractor forum, and he wants someone here on TBN that has an...

There is significantly less tread on the pavement for the fronts, even less after being grooved. I have 1200 or so hours on the grooved...

Just to throw this out there... Have you checked the air filter? Fuel / Air / Compression are required. The clicking sound in the video...

Yes they do remember! I ran a short electric wire along 100' of my fence to stop my GSD from running the fence line and creating a muddy...

Very nice job! We redid our split rail fence 4 years ago, and I can relate to the work involved.

I wouldn't worry about running a 7' blower on your L4760, particularly with an HST, where you can control the speed to match conditions...

I use a clamp on ball for moving my equipment trailer into and out of the lean-to on my pole barn. It's very tight, so the tractor fel...

I grooved my R4 tires about 8 years ago, and noticed a significant improvement in snow. With the grooves they are somewhat similar to...

I skimmed this thread, and don't have much technical knowledge to add. I will say that the filters themselves can operate on the edge of...

TractorData lists the rear lift capacity at 2494 lbs at 24". I realize that's not a recommendation for ballast weight, but at least the...