RjCorazza's latest activity

Since you've cleaned all of the high amp connections, consider replacing the cables themselves. They have been known to corrode on the...

The OP basically dumped 10 gallons of Walmart hydraulic oil into his expensive ag machinery, showed some vague pictures of almost...

I don't do that, mostly because my degreasing is done on a frequent basis before it gets too bad. I'm sure it works better on a warmed...

For the op's stated concerns, the choice is HST.

My vote is for Gunk degreaser for heavily soiled grease, and Oil Eater for routine degreasing / cleaning.

The full wiring diagram is buried in there also, with wire colors beginning at page 9M1 for the L10 series tractors.

It's poor form to delete (by editing) the original post on a thread.

The fuel solenoid may be getting shut down by one of several possible safety switches. Depending on your symptoms, switches to look at...

I agree that you should be focusing on the connections first. If reconnecting them doesn't change anything, try swapping them to see if...

I used to clamp off the fuel lines on both sides of the filter before changing. When I replaced the stock separator / sediment filter on...

I haven't been closely following the various "right to repair" movements, but I do know that the proprietary stranglehold did not work...

I suspect the nozzle can be touched to the container prior to opening, equalizing the potential static charge. The nozzle would also...

I switched from a 3 point auger to a ssqa loader mount auger and the difference is night and day. As PTSG states, the down pressure and...

Well, there is a fuel shutoff valve on the water separator / filter... Is that turned back on?

I think if I had a mechanical lift pump like on the M8200, I would break the fuel line somewhere for a temporary electric lift pump. At...