Recent content by Riley Simmons

  1. R

    Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

    Have another question about the fuel tank removal on my 4035. The service manual it talks about removing the steering column. Any ideas?
  2. R

    Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

    The two new lines don’t have the braiding on them. Only one left is the tank to filter line. So do you think I can just strip back the braid, get rid of the crimp and reinstall just the rubber line with a clamp?
  3. R

    Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

    So fore when it shutdown it will not restart with out bleeding it all over again. But haven’t tried bleeding it again after I replaced the line from the housing to the pump.
  4. R

    Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

    Thanks for all of your help, I blew out the air filter already and the inter air filter looks good. I will try running it with the fuel cap next. It doesn’t have a transfer pump the filter housing has a check valve built in. I saw in a forum were they talked about a time that actives in 20...
  5. R

    Mahindra 4035 after bleeding the air out run but at 2000 and greater rpm’s sputters and blows out black then followed by blue smoke.

    I have replace the return line to the tank. Replaced the filter and filter/bleed pump housing. And it still run but do the same thing but it was still getting air in the system. After talking to the service manager at the local Mahindra dealer he told me to replace the line going from the filter...
Top