Recent content by pooters

Hello, Got a bolt that looks like it attaches the front-loader support-frame to the main frame of the tractor that was either not installed properly, stripped or backing out. I've tried tightening it, but a socket will not fit over the bolt as there is little clearance between the frame and the...

Hello, Seems like a few folks are over-filling fluids while performing services on their tractors. Is there quite a bit of residual fluids remaining after pulling the plugs and filters? Are there any tricks for better draining? Like getting the tractor up to operating temp before service...

Hello, Got a new CK 20 HST with 10 hours on it and noticed that, quite frequently, the Hi-Low Shifter will not shift into low gear from neutral. When this occurs, I have to shift into high, move the tractor slightly and then can shift into low. I have also noticed the same condition, at times...

Just purchased a new Bush Hog rotary cutter (42") to go along with my new Kioti CK 20 HST. The field that I mow is uneven terrain and I found that I was constantly adjusting the height of the 3 pt hitch to maintain a relatively even cut. Sometimes the cutter would be too high and other times the...

Hello all, Just purchased a new CK 20 HST and have just 5 hours on it. So far, I'm quite happy with the purchase and the tractor has done everything to my satisfaction, given the limited operation time. I hooked up my new Bush Hog (42") to it the other day and did an hour or two of weed...