Recent content by PeteW

I recently bought a B8200 HST, a bit on the rough side. Transmission does not seem to take much load before it ceases motion. I drained the transmission oil and found some iron filings on the screen. I also got a 7mm ball bearing. Guess it doesn't look good. appreciate some insight !

Can I easily replace the old D750 engine in my B7100 with a D950 engine?

Can anybody tell me the specs, or correct size for the two belts down low front Kubota G5200H garden tractor which drive the rotary grass cutter blades?

I am fitting a new Jinma loader to my 284. Where are the hydraulic hoses meant to be plugged in? The hoses on the FEL are too short to reach back to the rear of the tractor.

I've just fitted an LW-6 to my new Jinma 284. I got all the air out of the system and all the rams are operating, but oil is not returning from the backhoe tank to the tractor. Also, I can only operate the hoe by holding the tractor hydraulic control lever on "Raise". Has anybody else had this...