Recent content by paintman161

I am looking for a zero turn mower but not sure what to even look for. I will have about 4 acres to mow with slight to extreme grades (the extreme grade will be done by push mower). Thinking zero turn and about 54-60" deck what are your thoughts on brands and what to avoid. Not sure if I i will...

Hey, So I may be going to look at a 2007 Kubota RTV900 with 533 hours- there asking 6495.00 plus tax. I was just wondering how are the RTV900's? I was debating between polaris rangers or the Kubota RTV's? I know the kubota is a diesel so it should have a little extra power behind it. This is...

Okay, I am getting ready to build my bridge across my creek. I have about half the telephone poles that i will be using for the piers, I plan on burying the poles 4-5' into the ground and have about 7'-8' above the lowest point of the creek. I will put two 2x12x5' across the pole for the beams...

So i got a Rhino 75C backhoe with a subframe for a TC40 tractor, but i need to make it fit on my Ford 1900 (1981) 4x4. I found where it attaches at the rear but am unsure where the front brackets would attach. Does anyone have a ford 1900 with backhoe subframe attached they can snap a picture or...

Does anyone have a ford 1900 with a backhoe on it? Where do you plumb the lines to for the back hoe?? Here are some pictures of the hydro block.

I have been trying to find one for awhile now and still no luck! I did find another thread where someone used the 3PH flow adjuster port to supply the backhoe with fluid and then used another spot just below that for the return this was on a 1710- they would raise the 3PH lever all the way up...

I just got the backhoe today, and i think i figured out a way to get it to attach by making two brackets and attaching it to the side of the loader mounting bolts using 3 bolts.

I am looking for a drawing, pictures anything showing the subframe for a Ford 1900. Want to put a back hoe on my tractor but cant find any information on the subframe, Like were it mounts on the front part of the tractor.

Also as for the hydraulics where would i connect the lines too? I don't have a mid hydraulics ports like you do you yours.

So i checked my Ford 1900 and i don't have any side mounting holes like you do, All i have is four bolt holes on the bottom of the tractor. (not sure what they are for.)

I was able to get the specs from rhino, they don't make a subframe for the 1900 but do make one for the 1920. The 44878 is for the 1920. The 53894 is for the TC40.

this is what i am looking at.

So I have a 24'x24'x 10'-6" pole barn. I am trying to figure out to use for heating it. It wont need to be heated all the time just in the Winter time when i am out there working. Most of the time I would be out there for maybe an hour or two during the winter time. This will be my storage and...

Okay so I want to build another bridge on my property, Last summer I re-did the old RR bridge and it turned out very nice! This year i was thinking of adding another bridge to cross another creek on my property. The problem with this one is I am starting from scratch. The creek width is about...