Recent content by OrangeJbird

I think this is what I need https://partscatalog.deere.com/jdrc/sidebyside/equipment/12115/referrer/navigation/pgId/7851760

It is closed-center pressure and flow compensated (PFC) And I know what I need for loader valving. I only want to know about the question in my original post.

I do not have service manual. Just acquired the tractor recently. I’m aware there’s a ton of knowledgeable folks here. Thought I’d ask.

Can I use these ports for power beyond for mid mount loader valves or do I have to add a block to the rear scv bank? 2011 with IVT and TLS

Much appreciates! Yep, typo. And I got the hydraulic info from TractorData so it’s probably wrong

I am looking at putting a Mahindra loader on a 6430 premium Deere. Attached is a picture of the loader valve. Does anyone know anything about this valve? Is it closed center load sensing? I’d like to use it through the power beyond circuit. Cross Mfg 180206 DSVR172ACXYE011 HYD VALVE Thanks for...

I’m also looking for used Deere or aftermarket FEL for my 2011 6430

I’m in the same boat. Looking to add a 640 loader to a 6430 Premium I just bought. I see Shortline has a kit, but I thought I’d check to see if you ever got yours set up?

2273001661

Our XU6168 Grammer seat is uncomfortable. The seat pad position is tilted forward too much for my liking. Wish there was adjustment for it. We can slide f/r, adjust weight, tilt back rest, adjust armrests, but that seat pad is just too uncomfortable. :mad:

With/without loader? Which tires? Ag/turf/r4 Do you have weight on the rear of the tractor? Tire ballast/wheel weights/weight on 3-point? Front wheel assist engaged/disengaged?

I slit the pipe and slipped it over the cutting edge and welded a couple tabs up to the cutting edge bolts.

I push first snows with front loader bucket curled up a little so it skims and packs a base. I have a 2” pipe on the back blade.

Anyone mount a hydraulic pump setup to be driven by mid PTO? Have a friend with 790 wondering. Someone gave him a pump that was once on the front of an 8n Ford. He’d like to set it up to power a grapple or other attachments. Not really interested in power beyond or whatever Deere kits available...