oldnslo's latest activity

Shows how good my memory is..

Wouldn’t that be 3 or 4 times of what that vintage of tractor would have cost when new?

If a piece of crud gets between the metal ball or poppet and seat they will leak. Look into the QD that is leaking to see if there is...

Why not mechanical drive with quick tach like used on factory snow blower or broom. Hydraulic maybe if you want to lift it way up but...

If you had a mid PTO it might be possible to power a front mount mower similar to front mount snow blower

No clue on that slot in the nut unless it was meant to bent in to act like lock nut once assembled but that is 100% pure guess.

What is the “heater plug” that was missing? Does the pump housing get significantly hotter than the inlet line to the pump? I made the...

You CANNOT 'tee' into pressure lines, every valve has to be added in series, you effectively have yours in parallel. The fluid, like...

Yes As long as the load is spread evenly. But, if moving around will the load stay uniform across all the casters?

Where do you have the gauge installed? If teed into the pressure line you will need to operate a function to see pressure.

To diagnose further you need to install a pressure gauge in the pressure line and watch this while the tractor is operating. There...

Is the valve accessible? If yes can you install a gauge in the pilot line on the valve section in question or swap pilot lines from a...

Is there a breather tube that goes from the valve cover to intake? If yes then it might be possible to get oil into intake if it is...

Do you have some way of covering or protecting the check block mounting surface? If yes that could be an easier solution since less risk...

Is there some way that you can slightly lift that boom segment with an overhead chain hoist or a jack underneath to relieve the tension...