oldnslo's latest activity

IMO most of those are a lack of attention and hurrying to get the job done. I do know farming is one of the most dangerous occupations...

Only way I know is if you can remove a cover or shield and watch the belt while mowing.

Does this mower have the rubber friction wheel drive? If yes watch the aluminum drive vs driven rubber friction wheel to see which one...

Do you have a volt ohm meter? If yes you can check to confirm getting power to the glow plugs. You can also disconnect the electrical...

Do you have a voltmeter or test light for 12 VDC circuits? If yes I would suggest checking for power to the starter solenoid when you...

Wish you would keep that kind of weather down south.🥵

I just looked on tractor house and was amazed at prices for a 420. Might want to look at that site as a point of reference.

was there a lot of loader work done with the tractor? Just wondering if that could put additional loading or thrust on that assembly...

That is quite the fleet of old blue iron. I do miss the simplicity of the 5000 & 5600 we had 40+ years ago.

Or provide a replacement vehicle while yours sits? I have had recalls and my dealer provided a loaner while my vehicle was out of...

Idle the engine down for smooth digging and rev it back up for travel. Running at 2,500 RPM should be fast enough to keep engine cool...

Leakage depends on the quality of the valve and are the cylinders not bypassing internally. You can ask dealer if there is a leak down...

Not sure on damaging anything going full stick but is concern of system pressure stalling the engine and or what are the pressure spikes...

Are the hose ends the same where they connect to the motor and PO check block? If yes could you just loop the C1 & C2 ports together...

Interesting thought on track binding but why does it work full speed reverse and not when trying to operate at less than full speed? If...