Hey group I finally finished the bearings and blades I set it up for corse cut when I got it it had 3 rows of 14 blades fine cut calla for 88 stations could I get by with 3 rows of 14 ?
No collor was on the right side. On the drive side the collar was locked against the pulley kinda like someone just thew it together. I ordered another collor. As far as the cutter being bent I haven't seen anything wrong once I get the new berings I'll get the drive shaft shop to look at it
Update i took the blades off still has vibration. I pulled the bottom pulley off it looked fine the whole cutter shaft slides back and forth.both bearings looks good.going to order new ones. I am stumped lol I'll also take it to drive shaft shop to have it balanced. My question is what keeps...
Hey my next question is the drive pulley is there anything specific on getting it off I noticed last night the drive pulley is off not in line with the rest of the drive system it cruves out I need to see about getting that aligned.
Thanks
Hello I need help with a 917 drum has muilti holes how many blades per row do I need and where to place them? Right now it has 14 scoop knives per row its unbalanced. Its 5 ft not sure if its fine or corse cut Bought it used any help would be appreciated
Thanks
Mike Henry
Hello I just got a 917 flail mower it has 3 rows of 14 corse cut knifes it is out of balance does. There's multiple holes for mounting does anyone have info how to put it back correctly? I am not sure if it's corse cut or fine cut mower
Thanks
Mike Henry
Hello I have a John deer 3038e and it's has white some when running when giving fuel or under load lots of white smoke any ideas what to check
Thanks
Mike Henry