nyone's latest activity

Did you clean the battery terminals?

I would start with cleaning the battery terminals. Then disconnect the signal wire like stated above. My tc40 died on me climbing a...

Good catch. I suprised the shaft even went together 90* off. Typicaly these are 3 spline with 1 being different.

Geez it's not like there a days drive appart and you dont even know the scope of the work.

Could your lift pump be getting weak?

Look up the starter relay mod.

Yup. Do this. I built a set of pin on forks and hardly ever changed them..then I got another tractor and one had forks and one had a...

Is the knocking in the lower end or up by the valve train? Could need a simple valve adjustment.

If everything works I woulnt go tearing stuff appart just to find where they came from. A bit clue on where they came from may be...

Bent pins are prob just the start of the problem. Bent pins usualy means you have oval holes.

I wish my machine came with a 3rd function..it did come with a rear remote. But its kind of awkward lifting/curling the grapple with the...

My suburban with Michelin ATX tires would need 4x4 on to also not be stuck on flat grass. They had 75% tread too. Worst AT tire ever...

Long term investing ignores the emotional cries we hear daily. Amen

You can handle it. 98% of the job is nuts and bolts. 1% replacing the seal and 1% making sure your changing the right seal. Clean that...

A1 and b1. I suspect the number correlates to the spool. And the letter the port. If not..just swap hoses. You want the cylinder to...