number two's latest activity
-
NNot all Dealer service centers are top notch. I was recently inquiring on a JD 4320 that was 1.5 hours away. I was asking if the fluids...
-
Nnumber two reacted to quicksandfarmer's post in the thread Looking for 24mm or 15/16" pins with
Good Post.
An update: I was able to solve the problem by taking a M24 bolt and drilling a 5/32" hole in it for the retaining pin. -
Nnumber two reacted to Fetch_21's post in the thread Fixed - Grease zerk replacement. with Good Post.
Glad it's fixed...for others / future - if you can get it removed (or not), waving a torch over it for a little while will typically get...
-
Nnumber two reacted to Complete Turf Care's post in the thread Pictures from an athletic field contractor with Good Post.
One last look at the field we planted on May 23. It is 100% grown in and I have submitted my final invoice. It turned out just as I...
-
Nnumber two reacted to bigtiller's post in the thread Looking for a new tool, 4lb sledge replacement, power tool option? with Good Post.
My go-to tools for forming metal are... 15" Crescent wrench 24" pipe wrench 36" pipe wrench. Slip the jaws over the bent part, tighten...
-
NI was always taught to engage pto at low rpm, ease out the clutch, and then run up the rpms. Heck, my Massey Hydrostatic has a clutch...
-
Nnumber two reacted to Hay Dude's post in the thread The Life of a Custom Mowing contractor with Good Post.
No doubt. I’ll park the baler in the shade if it’s hot. Worst I ever had was when I jammed the baler with a fungo bat sized branch. had...
-
Nnumber two reacted to Hay Dude's post in the thread The Life of a Custom Mowing contractor with Good Post.
A few more from Saturday. Me & Mrs HD went to a nice fireworks display that night, grabbed a little dinner, too. Beautiful...
-
Nnumber two reacted to old and tired's post in the thread Wood chip ground cover and trail building with Good Post.
I've been spreading wood chips on my trails for 20 years... it gets old doing it but it looks great afterwards and last for 4 or 5 (???)...
-
Nnumber two reacted to dougtrr2's post in the thread Wood chip ground cover and trail building with Good Post.
Every few years when the power company trims trees I try to snag chips. I put them on my trails and although they can wash out under...
-
NThis is my experience also. I have never had a complaint when plowing residential driveways beginning at around 0500h. The local noise...
-
NThe bucket on the backhoe of the old B7100 had a zirk that got smudged by rock so the nipple wouldn't seal to the grease gun and the...
-
Nnumber two reacted to Little Red Tractor's post in the thread Fixed - Grease zerk replacement. with Good Post.
I had a couple that were pressed in. Had to cut a thread for a replacement.
-
Nnumber two reacted to masscity's post in the thread Fixed - Grease zerk replacement. with Good Post.
I used to operate a P&H Crane and we had problems with fittings. Now years later I found out that it was clay based grease. For years...
-
Nnumber two reacted to aircommuter's post in the thread Fixed - Grease zerk replacement. with Good Post.
Sounds like it’s fixed. Just for future reference I have had good success gripping and turning things that are too tight or rounded of...