number two's latest activity
-
NYou need to properly diagnose the problem. Don’t just jump into parts replacement mode. Get an experienced a/c technician involved...
-
NAt least you were at home and didn't have to suffer any embarrassment. Long time ago I decided to do an oil change on my 1 ton diesel...
-
Nnumber two reacted to flyerdan's post in the thread Starter not getting full voltage with
Good Post.
It could be a bad cell in the battery, check the voltage at the battery terminals when engaging the starter. If it drops, bad cell. If... -
Nnumber two reacted to M59's post in the thread Regret not getting a backhoe for my tractor with Good Post.
Root/ Frost ripper on custom quick attach that mates to the KX40 excavator tools and a few stumps. Stump with huge tape root was 24"...
-
Nnumber two reacted to bdhsfz6's post in the thread Regret not getting a backhoe for my tractor with Good Post.
I bought my first backhoe attachment when I was in my 40's and it took less than 10 minutes to put it on and do the take off. When I was...
-
Nnumber two reacted to 3930dave's post in the thread Your last generator Maintenance Run with Good Post.
No high-frequencies in one ear now, so I wouldn't even try to rate audio systems today..... but these conversations are reminding me of...
-
Nnumber two reacted to JimBinMI's post in the thread 2014 BX1870 Steering Frame Broke with Good Post.
Back in business for under $300. Lots of time but feel accomplished. 😎
-
Nnumber two reacted to TORQUIN's post in the thread Kubota V1702 engine - Is 200-250 PSI too low compression to run? with Good Post.
A trick for starting a diesel without starting fluid, is a gas-soaked rag over the intake. This is safer than starting fluid as all that...
-
Nnumber two reacted to Farmer495's post in the thread Ordered an M5-091 cab / no loader with Good Post.
Too bad they didn't take care of the speed coefficient. Seems like normal set up to me.
-
NWell, it's back together. Shop made a pretty radiator out of mine! Stat opens fine, 20 + temperature drop across radiator. Cannot really...
-
NLadies and gentlemen, as promised some photo's. Tomorrow it will dawn a canopy, and the 401 rotary cutter.
-
NYour post makes it sound like you haven't had any exposure to this sort of work. If you don't have a WSM and good mechanical aptitude...
-
NOnce you open the system you really should run a vacuum to remove any moisture and check for leaks. After a compressor replacement I...
-
NI ended up jacking up the bucket, just enough and slowly tapping the pin out. Got everything reset and bucket is operating well and it’s...
-
NIf the mice are shot with full metal jacket bullets, they could then be sold as Hole Foods...:rolleyes: