number two's latest activity
-
Nnumber two reacted to tjandrews's post in the thread How about a grease cartridge thread? with
Good Post.
At 76, I sometimes think that I should have one of my doctors install a zerk on each knee. Then I could give them a couple of shots each... -
Nnumber two reacted to boatmoter's post in the thread How about a grease cartridge thread? with Good Post.
I use mobile one synthetic grease or sometimes marine grease, it stays on even if it goes underwater. I use a hand pump grease gun I...
-
Nnumber two reacted to azbinder's post in the thread 2014 BX1870 Steering Frame Broke with Good Post.
This is a cast material. Probably aluminum. Not sure how hard it would be to weld them back together. Items 40 & 70...
-
NEagle cans are galvanized. We used some for over 15 years.
-
NMy first gas can was galvanized steel and lasted less than a dozen years before I had to replace it due to a leak from rust. I'm...
-
Nnumber two reacted to ultrarunner's post in the thread Grease - is there no better way? Can we talk about this? with Good Post.
Almost applied for a factory union job of machinery greaser… To do it right required inventory, schedules, etc… I had no idea such a...
-
NThe cheap KD pliers I've got have worked just fine on everything I own until I needed to replace the kingpin seals on my GC. I'm not...
-
NThats a nice set but I found that no matter how many tools ya got it aint the right one. [emoji30] I also have a lot of modified to make...
-
NI bought this K&D/Napa set years ago. They don't have the "deep" jaws that you need. Twelve pliers and I still had to "hack" one up. I...
-
Nnumber two reacted to WM75Guy's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
The Tractordata info is wrong, it will not lift that much. I struggle with my 16LA loader, the previous model to the 250TL, to get a...
-
Nnumber two reacted to rScotty's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
Mark, reading through your original post, in my mind the most important reason you give for adding weight would be so you can stop...
-
Nnumber two reacted to RjCorazza's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
I would agree that 1000 lbs would be a good starting point, along with the 55 gallons of fluid in the tires. I like having the loaded...
-
Nnumber two reacted to dodge man's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
I’m going to say 1000 pounds minimum, 1500 might be better. The owners manual might say. If your tractor will lift it and almost be...
-
Nnumber two reacted to AaronD81's post in the thread How much ballast for a 40hp machine (TC40DA) with Good Post.
My tractor is similarly sized and the owner's manual recommends 700lbs. I also used a plastic barrel with one of these Amazon hitches...
-
Nnumber two reacted to Hay Dude's post in the thread The Life of a Custom Mowing contractor with Good Post.
Back on it again today. (2) smaller HOA’s this time. One is far from home base (about 8 miles). Looks like we got us a phragmites...